Basic I O Interface setup info:
Press enter on Basic I/O interface.
The next screen, Type has a couple of choices. Press the enter key to see the 3 options.
Usually you will
either choose Can I/O or Anilam IPI. Click on the link to see 
Anilam IPI setup information.
The Time out choice represents how long we should wait between doing any m-function and wait for a finish input to occur. After the amount 10,000ms (Default value) the CNC will display an error Timeout in spindle sequence as an example. Increasing this number may help if you are getting an error message.
The next choice Issue Spindle stop on either a servo fault or E-stop, is a Yes or No answer. Leave set to yes!
The next screen will take you to the I/O nodes screen, press the enter key to see the next menu.
On the next menu press the enter key on DSP2 node. Click on the
link to see
DSP2 Node setup information.
Move down to Can Node 0 and press the enter key to see the next
menu. Click on the link to see
Can Node 0 setup information.
If you have 2 can nodes detected then move down to Can Node 1 and
press the enter key. Click on the link to see
Can Node 1 setup information.
If you have Anilam IPI as your TYPE, then click on the link
Anilam IPI setup information.
