DSP2 Node setup info:
Press enter on DSP2 node choice to see the next menu.
If you have a remote start/stop option connected to the back of the console this is how you set it up.
Press the enter key on Ext Start choice and then arrow down to active High and press the enter key.
The next screen will show you what it should now say.
Move down to Ext stop.
Press the F1 (INPUT) key and move down to input 1 and press the enter key.
Press the enter key on Ext Stop. Move down to active Low and press the enter key.
The next screen is what you should see when you have completed setting up to use the remote Start/Stop option.
The last choice Auto/Manual is for the Auto/Manual switch on the back of the console. This allows the operator to manually move the X Y and Z axis while controlling the spindle if the switch on the back is set for manual spindle operation! To see how it is setup do the following: Move down to Auto/Manual choice.
Next press the F1 (INPUT) key and move down to input 2 and then press the enter key again.
On the next screen is what this choice should say!
