Builder Text setup info:
Press the enter key on builder text.
Please note, to use either builder text for warnings or errors you must write an IPI program to have these messages get passed to the CNC screen!
If you are going
to write an IPI program then change the top choice to YES! Any questions
regarding IPI refer to manual 
70000416D.
After changing the top choice to YES, press the F10 (EXIT) key about 5 times and then press the F1 (SAVE) key. Now press enter on setup utility. Press enter on builder setup and move down to Builder text and press the enter key.
You can now press the enter key on Edit error messages. NOTE: we don not advise to use this feature to often because, if an error is detected on the CNC from IPI, you must clear the error condition and then reboot the cnc to let us run again! It is better to use the warning messages and let IPI handle the temporary stopping of the CNC and once the warning input is corrected the CNC can immediately continue.
Below are a couple of examples of warning messages, you can create your own messages.
