Digital Amplifier settings setup info:
Press the enter key on Digital Amplifier Settings.
If you are not
using Anilam’s kit style AC Brushless Digital amplifier part # 
33001279, then make sure Active digital amplifiers are disabled!
Enabled means you are using Anilam supplied digital amplifier in your servo box.
The Balance adjustment value allows you to set how much voltage we output when you are trying to balance our drive boards in the motion setup and testing screens.
The range or values that we will allow is from .5 mvdc to 100 mvdc.
The signal gain adjustment value allows you to set how much voltage we output when you are trying to set the signal gain on our drive boards in the motion setup and testing screens.
The compensation adjustment value allows you to set how much voltage we output when you are trying to set the compensation on our drive boards in the motion setup and testing screens.
Table 2-5, Digital Amplifier Parameters
|
Digital Amplifier Parameter |
Definition |
|
Active digital amplifiers |
Enables digital amplifier interface for a specific axis. [Default: Disable] |
|
Balance adjustment (mV) |
Used to increase/decrease the steps when running the Balance test (up/down arrows). [Default: 0.5 mV] Valid range: (0.3 to 100.0 mV) |
|
Signal Gain adjustment (%) |
Used to increase/decrease the Gain Adjustment step when running Signal Gain test (up/down arrows). [Default: 0.10 %] Valid range: (0.01 to 2.00 %) |
|
Compensation adjustment (%) |
Used to increase/decrease the Compensation Adjustment step when running Signal Gain test (right/left arrows). [Default: 0.02 %] Valid range: (0.01 to 2.00 %) |